Clogger Zero Gen 2 Chainsaw Trousers- Grey/Green
Certified by Bureau Veritas NZ Ltd to AS/NZS 4453.3:1997
Fit & Sizing:
Slim “movement-ready’ cut with plenty of stretch. Extra leg length is to allow for knee flex, especially when wearing climbing spurs. See the size chart for jean-equivalent sizes.
The first generation of the Zero has been a game changer for the industry. The first lightweight, cool chainsaw pants. With Zero, you don’t sweat all day long when you are climbing.
The new Zero does the same as his older brother. But better. Like the original, it embraces your movements: you are able to stretch, climb and jump freely. With the Gen2, you don't have to be as worried about tears and rips – the outer fabric of the garment been reinforced! Of course, Zero's fit and style stays the same. You will look good in the trees… or on the ground!
Now available in standard and short lengths.
- Certified by Bureau Veritas NZ Ltd to AS/NZS4453.3:1997
- Uses Arrestex HP advanced chainsaw protection material which is light, cool and quick drying, rated to 20 m/s
- Lightweight design, less than 1 kg (Medium)
- Outer fabric, engineered to lower body temperature by dispersing body heat through breathability and the use of Nilit® Breeze yarn - Nilit® is proven to reduce body temperature
- 4-way stretch fabric for greater freedom of movement and flexibility with elasticized thread in the seat for extra give
- High-tenacity nylon and a ripstop weave for a 1.5x stronger outer
- Abrasion resistant fabric over the knee, the inside of the calf and ankle areas increasing the durability in these high wear areas.
- Ultra-high tear strength Dyneema® fabric at the right calf to protect against small cuts caused by the chainsaw when hanging off the harness
- Elasticized waist for a snug fit and extra comfort
- Wide belt loops to fit up to 50 mm belt
- Stronger and more durable zippers with a better seal to reduce the risk of sawdust damage
- Special zipper pulls on the pockets to make accessing your pockets easy even when wearing gloves
- Two zipped hip pockets; two zipped thigh pockets individually sewn to be able to remove saw dust with additional pocket on the left thigh, all accessible while wearing a harness
- High-visibility panels front and rear
- Tough, large always open mesh vents at rear of both legs for cooling
- Lace hooks to prevent the pants from riding up
- Slim fit with just the right amount of fabric for easy movement
Designed and made in Invercargill, New Zealand
|Actual Garment Waist|
|Approx Jeans Waist Size|